Miliput Sand Bags
by: Don Franklin

introduction
I've had a few people ask me how I made the sand bags for my Sherman, so here it is. I start with Milliput standard yellow-grey. This comes in two sticks that you cut equal parts of and knead together. It helps to keep a bowl of water on the table while working with this product because it does get sticky. The water will lengthen the set up time and cut down on the stickiness while you work with it.

making bags
After kneading a roll about 1/2 inch in diameter and another about 1/8 inch you are ready to start. Lay the Milliput down on some wax paper and cut about a 1/16 of an inch off the large roll. Roll this into a ball with your fingers (note the instructions say to wear rubber gloves while working with this product.) Now work it into a triangle shape. Why? Real sand bags are just that, an open-ended straight bag filled about ĺ full of dirt then tied off by strings that are attached to it or by some other means if the string is missing. After tying the draw string it looks like a triangle until you drop it in place.

Next cut a 1/16 inch off the small roll. Roll this into a ball and place at the top of the triangle shaped bag. This is to represent the section of the bag that you have tied off. The mulliput is sticky enough that the small ball will stay there. Now take a Xacto knife and make slot in the small ball parallel with the bag to represent the opening. I pressed the tip of the knife in and moved it back and forth to get what I wanted. With this done you are ready to place your sand bag.

Dampen a finger on the hand not holding the sand bag so that you can press the sand bag down into place without it sticking to your finger. Place the bag where you want it and press into place with the dampened finger. I donít worry about fingerprints, as the bags should have texture on them anyway. Repeat these steps until you have placed all of your sand bags. Then let them dry over night.

I choose to make these bags represent burlap sand bags. Modern day U.S. sand bags are olive drab in color, from Vietnam through today, and they are no longer made of burlap, they are woven nylon. Other countries will have different material and colors so check references before painting. For these bags I painted them with Tamiya acrylic Buff. I used acrylic so that it would not react with the oil wash to come next. After the paint dried I applied a wash of very thinned Vandyke brown oil paint. I let the paint flow over the entire sand bag and crevasses. Making sure paint got in the small slot that I had made with the Xacto knife. It takes a long time for this oil wash to dry so you can work it with a dry brush to get the effect that you want, more brown or less brown. After this dried I coat it in a flat clear coat and dry brushed the Buff to add highlights.

There you have it. It is probably best to do a few test ones to get the size and amount to use solution down before tackling a sand bag bunker. Also the materiel that I mixed started getting to dry to work with close to the end off my project even with adding and knead more water into it. Be sure to experiment and have fun!



This article comes from Armorama
https://www.armorama.com