Thanks Mario, it's a long grind :-/

With the 7 minutes available to me at the bench today, I refined the suspension support towers by clipping the corners off & adding the radii...



More to follow...

The mounts for the rear suspension rockers needed to be built up. This will be multi-staged, noting that some levelling & laminating is required.





Once that was glued & set aside for drying, the mounts for the radius arm bushes for the front axle were commenced. Again, this'll be a multi-step operation, building up the framework before finishing off the detail. Most of the radius arm bushes mounts were built up using 3.2mm square tube.



More to follow....

In the middle of an involuntary absence from the bench, normal service will resume shortly.

Back to the bench. Excellent.

The intermediate suspension hangers were continued. These needed to be capped and then extended. Finally, the extrusions were added using 0.75 x 1.5 mm strip.

Capped & extended:



Extrusions added:



Quite a small update, but an update it is.

More to follow...

After a prolonged absence, I've managed to get back to the bench.

I'm zeroing in on the suspension at the moment: hence today's job of adding the rubber bump stops to the front of the chassis.

These were made pretty easy to make from a section of rectangular-section styrene with tapers cut into it. Once neatened up, they were mounted via 0.75 x 1mm scraps to represent the stand-off from the front chassis rails.



More to follow...

Well, after a brief seven-month trip away, it's almost time to return. To the build...

Welcome back. Looking forward to seeing the progress.

Mario